Garage cabinets inSpokane, Washington.
A lot of Spokane garages were built back when cars were narrower. Detached, single bay, and tight enough that you fold the mirrors on the way in. Storage in a garage like that has to climb the wall, because there is no floor depth to give away.
In a tight garage, go up, not out.
From the South Hill to the older streets near downtown, garages here run smaller than anywhere else we work. Every inch you commit at floor level is an inch you do not get back.
- 01
Depth is the whole conversation
Pantry cabinets are 24 inches deep. In a wide suburban bay that is nothing. In an old Spokane single-car garage it can be the difference between opening the car door and squeezing out. Overheads are 12 inches deep, so storage above the hood costs half of what the same storage costs beside the fender.
- 02
A Tradesman run splits the difference
The Tradesman configuration is not a solid block of deep boxes. A 10 foot run pairs two 36 inch pantries with 12 inch deep overheads mounted over base cabinets, so the deep storage stays contained to one section of the wall and the rest of the run stays shallow. On a tight wall that layout usually beats a straight run of pantry doors.
- 03
Detached garages get measured, not assumed
Older detached garages are rarely square, and the wall you want is often interrupted by a side door, a window, or framing nobody would build today. We measure in person before a single cabinet is built, because that is the only way a fixed run lands flush on a wall that has been settling since long before you owned it.
Built for how you use the garage.
Rhino Coatings is licensed in Washington and runs crews into Spokane every day; the shop sits 34 miles east in Coeur d'Alene. There is no job minimum, so a single-bay detached garage on the South Hill is a real job rather than a favor. The cabinets are made-in-USA melamine, built to the layout we measure on site, and set by the same crew that installs our floor coatings.
There are two series, and in Spokane the choice usually comes down to floor space rather than looks. The Garage Vault is a wall of full-height pantry doors, 84 inches tall, 24 inches deep, in 36 or 48 inch widths, which is the right answer when the garage is wide enough to spend the depth. The Tradesman mixes pantries with shallow overheads, base cabinets, and a slatwall run for hanging tools, and it is what most older Spokane garages end up with. Either way, colors get chosen from 18 melamine finishes in person.
- Made-in-USA melamine, not a flat-pack box you assemble on the garage floor
- Garage Vault: floor-to-ceiling pantry doors for a clean wall of storage
- Tradesman: bases, overheads, and a slatwall run for hanging tools
- 18 colors, matched in person at your design consultation
CITIES SERVED
Spokane · Spokane Valley · Liberty Lake · Cheney · Mead · Airway Heights
Designed on site, built to your wall.
The design consultation and the build come first, and the install visit follows, whether the floor is going in with them or already finished.
- 01
Measure and design
We measure the wall, talk through how you actually use the garage, and lay out a 10, 12, or 14 foot run in the series that fits. Colors get picked in person, not off a screen.
- 02
Build and finish the floor first
Cabinets are built to your layout while the floor goes in. Doing the coating first means the cabinets land on a finished floor instead of a bare slab.
- 03
Install and hand back
The same crew that coated your floor sets the cabinets, levels the run, and hangs the doors. Cabinet-only installs are welcome too if the floor is already done.
Garage cabinets questions in Spokane.
Will 24 inch deep cabinets fit in an old single-car garage?
Sometimes on the back wall, rarely along the side. That is an honest answer rather than a sales one, and it is why we measure before quoting. On a lot of older Spokane garages the workable plan is overheads at 12 inches deep along the length of the bay, with the deep pantry section kept to the end wall where nothing has to drive past it.
Are you actually licensed to work in Washington?
Yes. Rhino Coatings is licensed in Washington and our crews are in Spokane daily, from Airway Heights to Mead. You get the same in-house installers, the same made-in-USA cabinets, and the same 18 finishes we run on the Idaho side. Call 208-500-1043 and a Spokane design consultation is usually easy to get on the calendar.
All my tools are on a pegboard right now. Is the slatwall an upgrade?
It is the part of the Tradesman series people notice most. The slatwall run is built into the layout rather than screwed to whatever studs happen to line up, and it sits over the base cabinets so the wall and the work surface belong to the same run. Everything that currently hangs on a nail or lives in a bucket goes there instead.
Can we do cabinets without a floor coating?
Yes, and in Spokane it is a common request. Older garages here often got the floor ground and coated years before anyone thought about storage, so cabinet-only installs are ordinary work. If the slab is still bare, doing both means the coating goes first and cures, then the same crew sets the run on the finished floor.
How does the layout actually get decided?
At the on-site design consultation. We measure the wall, look at how you get in and out of the garage, and talk through what has to be behind a door versus what should hang in sight. Then we lay out a 10, 12, or 14 foot run in whichever series fits. Nothing is built until that drawing matches your garage.
Next steps in Spokane.
NEARBY
Garage Cabinets in Spokane Valley · Garage Cabinets in Coeur d'Alene · Garage Cabinets in Post Falls
Pour a floor
that outlasts
the building.
Tell us the slab. We'll send a quote. Usually same day, always with photos and a fixed price. No high-pressure sales nonsense.
Takes about 45 seconds. We'll text or email you within the hour.